U100 Series Specifications*
Overall System |
| |
Operating Frequency |
UHF band
"x" systems: 656.125 MHz to 668.500 MHz
non-"x" systems: 728.125 MHz to 740.500 MHz |
| |
Number of Channels |
100 total |
| |
Frequency Stability |
±0.005%, Phase Lock Loop frequency control |
| |
Modulation Mode |
FM |
| |
Normal Deviation |
±10 kHz |
| |
Operating Range |
300' typical (ATW-U102: 200' typical) |
| |
Operating Temperature Range |
41° F (5° C) to 113° F (45° C) |
| |
Frequency Response |
100 Hz to 15 kHz |
ATW-R100 Receiver |
| |
Receiving System |
Dual independent receivers, automatic switching
diversity |
| |
Image Rejection |
35 dB nominal |
| |
Signal-to-Noise Ratio |
107 dB at 30 kHz deviation (IEC weighted), maximum
modulation 75 kHz |
| |
Total Harmonic Distortion |
<1% (10 kHz deviation at 1 kHz) |
| |
Sensitivity |
26 dBµV, (S/N 60 dB at 5 kHz deviation, IEC-weighted) |
| |
Intermediate Frequency |
45 MHz, 10.7 MHz |
| |
Audio Output (balanced) |
31.6 mV (at 1 kHz, ±5 kHz deviation, 10k ohm load) |
| |
Output Connector (balanced) |
XLRM-type |
| |
Monitor Headphone Output (typical) |
75 mW max. total at 1 kHz, 1% T.H.D., into 32 ohm
(each channel) stereo headphones |
| |
Monitor Headphone Jack |
3.5 mm TRS, signal on both Tip and Ring |
| |
External Power Requirements |
12V DC nominal, 200 mA |
| |
Batteries |
Two 9V (NEDA type 1604) alkaline, not included |
| |
Current Consumption |
130 mA typical |
| |
Battery Life |
Approximately 5-7 hours (depending on battery type
and use pattern) |
| |
Dimensions |
3.35" (85.0 mm) W x 4.53" ( 115.0 mm) H x
1.42" (36.0 mm) D |
| |
Net Weight (without batteries) |
12.0 oz (340 grams) |
| |
Accessories Included |
Two flexible UHF antennas; control screwdriver;
mounting pouch; hook and loop fasteners |
ATW-T101 Body-pack Transmitter |
| |
RF Power Output |
50 mW Max |
| |
Spurious Emissions |
Under federal regulations |
| |
Input Connector |
TB5M |
| |
Line Input Impedance/Level |
100k ohms/3.16V max. input at 1 kHz, 1% T.H.D. |
| |
Battery |
9V (NEDA type 1604) alkaline, not included |
| |
Current Consumption |
50 mA typical |
| |
Battery Life |
Approximately 8-10 hours (depending on battery type
and use pattern) |
| |
Dimensions |
2.52" (64.0 mm) W x 3.78" (96.0 mm) H x
0.91" (23.0 mm) D |
| |
Net Weight (without battery) |
5.0 oz (143 grams) |
ATW-T102 Plug-on Transmitter |
| |
RF Power Output |
50 mW Max |
| |
Spurious Emissions |
Under federal regulations |
| |
Input Connector |
3-pin XLRF-type |
| |
Battery |
9V (NEDA type 1604) alkaline, not included |
| |
Current Consumption |
60 mA typical |
| |
Battery Life |
Approximately 7-9 hours (depending on battery type
and use pattern) |
| |
Dimensions |
1.58" (40.0 mm) W x 4.32" (109.8 mm) H x
1.58" (40.0 mm) D |
| |
Net Weight (without battery) |
6.2 oz (177 grams) |
*Except for operating frequencies, specifications for
"x" and non-"x" units are
identical. |